Automotive Carpet Service Seattle .... floor mats auto mats custom car mats.
Plush Automotive Carpet. Can be cut to fit your vehicle exactly. Can be made into custom floor mat and finished to your
recsize. Pick up today!!! Car carpet comes in 6 foot widths three colors in-stock. Call Seattle 206 219 9148
6 x 8 ft ins-tock only $48.00, Will do most automobiles including trunk.
Here are some basic instruction for installation
• Remove sill plates (metal or plastic strip holding Automobile carpet at threshold of the door). Be sure to keep the screws.
• Before you unplug any wiring or electrical components, disconnect the battery cables first
• Remove the front seats and seat tracks by removing the floor bolts in the seat tracks. Be sure to check for and disconnect any electrical connections. Some seat bolts go through the bottom of the vehicle. In this case, remove rubber plug to access these bolts. A deep well socket may be needed.
• If your car is a general motors from 1958 to 1964, you will find that the gas pedal can be taken off by lifting pedal off sideways. This will permit easier installation of the front car carpet. When replacing the pedal, simply force it back on with your hands or foot.
• Remove rear seat cushions and center console if applicable.
• In some vehicles, seat belt mounting will not affect automobile carpet installation. In other vehicles, seat belt floor brackets may have to be removed for total access for removing old car carpets and installing new. Sometimes these are held with standard bolts or nuts, sometimes they are held wit a bolt that has a star shaped, recessed opening. These can sometimes be grasped and turned by vise-grip pliers. Otherwise, most auto supply stores have the star bits available for sale for use with standard sockets sets. They are called torx or star bits.
• It may be required to remove or loosen the kick panels and other moldings to remove the old automobile carpet.
• Remove the old car carpet but KEEP IT! Do not discard the old car carpet yet.
Remove the old auto carpet padding, leave the body insulation on the floor (do not remove the catalytic converter shield if the vehicle has one on the floor)
Vacuum or sweep the floor, remove all loose matter
Use a stiff wire brush on rust spots and a mild solvent to clean the floorpan if necessary
Place the old automobile carpet over your new carpet.
Mark any holes or additional cutout on the carpet with chalk
Rike Inc. Seattle 206 219 9148 Tacoma 253 200 4291